vurbingo.blogg.se - Wire library download arduino

ESP-specific APIsĪPIs related to deep sleep and watchdog timer are available in the ESP object, only available in Alpha version.ĮSP.deepSleep(microseconds, mode) will put the chip into deep sleep. See if you want to suggest an improvement or open an issue related to SoftwareSerial. SoftwareSerialĪn ESP8266 port of SoftwareSerial library done by Peter Lerup supports baud rate up to 115200 and multiples SoftwareSerial instances. Setting the Clock polarity (CPOL) is not supported, yet (SPI_MODE2 and SPI_MODE3 not working). SPI library supports the entire Arduino SPI API including transactions, including setting phase (CPHA). Wire.begin(0, 2) on ESP-01,Įlse they default to pins 4(SDA) and 5(SCL). Wire library currently supports master mode up to approximately 450KHz.īefore using I2C, pins for SDA and SCL need to be set by calling EEPROM.end() will also commit, and willĮEPROM library uses one sector of flash located just after the SPIFFS. Whenever you wish to save changes to flash.

You need to call EEPROM.begin(size)īefore you start reading or writing, size being the number of bytes you want to use.ĮEPROM.write does not write to flash immediately, instead you must call mit() This is a bit different from standard EEPROM class. Instead, set a flag inside the ticker callback and check for that flag inside the loop function. It is currently not recommended to do blocking IO operations (network, serial, file) from TickerĬallback functions. Library for calling functions repeatedly with a certain period. WiFiServer, WiFiClient, and WiFiUDP behave mostly the same way as with WiFi shield library.įour samples are provided for this library. Sent to the multicast or unicast address.

You can use udp.destinationIP() to tell whether the packet received was Udp.beginMulticast(WiFi.localIP(), multicast_ip_addr, port). When listening to multicast packets, replace udp.begin(port) with Udp.beginPacketMulticast(addr, port, WiFi.localIP()). When sending a multicast packet, replace udp.beginPacket(addr, port) with

WiFiUDP class supports sending and receiving multicast packets on STA interface.

WiFi.printDiag(Serial) will print out some diagnostic info.

WiFi.localIP() is for STA, WiFi.softAPIP() is for AP.

WiFi.macAddress(mac) is for STA, WiFi.softAPmacAddress(mac) is for AP.

call WiFi.softAP(ssid, password) to set up a WPA2-PSK network (password should be at least 8 characters).

call WiFi.softAP(ssid) to set up an open network.

WiFi.mode(m): set mode to WIFI_AP, WIFI_STA, WIFI_AP_STA or WIFI_OFF.

This is mostly similar to WiFi shield library.

Other libraries (not included with the IDE).

mDNS and DNS-SD responder (ESP8266mDNS library).